07-21-2021, 09:12 PM
JustFlight PA-28-161 Warrior II v0.1.0
|
07-24-2021, 12:17 PM
08-05-2021, 09:40 PM
Hi,
v0.2.0 - PMS-50 GTN 650 integration - FDE Tweaks - Wheel fairing option saved with state - Dome light texture position fixed - Beacon light control assignments fixed - Turn coordinator texture fixed - EFB sounds on/off clickspots*added - EFB warning added for engine flooding due to incorrect primer usage. Flooding prior to flight can now be resolved either by following the POH checklist (engine start with mixture/fuel pump off) or by waiting for a short period. Flooding in flight will now cause temporary engine splutter rather than total failure. - Cockpit texture tweaks for improved appearance - Tutorial flight plan fixed - KN62 inner knob animation fixed - Sim Update V control system compatibility fixes: * Cabin heating controls * Parking brake lever * Window latch * HSI and DI knobs * GPS 100 ON/OFF button https://file.cm/1pt84xiqtbbc
11-20-2021, 05:45 PM
Hi,
v0.3.1 Note: SEE README.TXT AFTER EXTRACTING! Please follow the activation procedure again even if you used previous version of this aircraft. Changelog : v0.3.1: Elevator trim axis has limited range - fixed COM/NAV radio volume and power logic improvements Further tweaks to cockpit instrument reflections Cockpit screen clickspot logic improvements Landing light effect repositioned for better match with model PUMP ON and PUMP OFF assignments fixed Pilot visible when cold & dark – fixed v0.3.0: Exterior model parts (e.g. pilot) showing up in cockpit when a flight is ended - fixed EFB tab black edges - fixed Version number is now shown on the top bar of the EFB OAT is now shown on the top bar of the EFB (Fahrenheit or Celsius depending on selected MSFS unit of measure) Wheel touchdown effects added Cabin heat control interactions fixed Beacon light no longer remains off when in cockpit view PUMP ON and PUMP OFF assignments can now be used to control the fuel pump switch Elevator trim axis direction reversed to match behaviour of default aircraft Panel lighting will now be set according to weather conditions as well as time of day as part of the aircraft states KN62 DME speed/time not shown after flight has been restarted - fixed Autopilot roll instability - fixed Radio lights can now be manually adjusted with SET NAV LIGHTS assigned Elevator trim wheel tooltip and mouse-wheel sensitivity - fixed Dome light knob tooltip - fixed Dome light will now fail if the overhead lights CB is pulled COM/NAV volume now included in state save Propeller texture/material tweaks Transponder ident added Exhaust heat haze direction fixed Yoke timer usability in VR fixed Sun visor reflections fixed GPS 100 headwind/tailwind logic fixed Rotating beacon is now controlled by the anti-collision lights switch Exterior lighting effects improved Instrument reflections reduced Correct ASI and RPM scales added to HUD Missing co-pilot fixed https://file.cm/y071twoe0y9o
02-24-2022, 08:49 AM
Hi,
v0.3.2 Note: SEE README.TXT AFTER EXTRACTING! Please follow the activation procedure again even if you used previous version of this aircraft. - Avionics switch no longer turns off when the battery master is selected off - HUD flap scale fixed - Rudder trim animation improved - Elevator trim animation improved - NAV 1 ident not audible - fixed - DATCON and HOBBs animations fixed - GPS 100 heading value no longer affected by drift - Autopilot now supports on/off control assignments - Pilot no longer visible in hanger view - Minor sound tweaks - ASI TAS scale position now included in state saving - Altimeter inHG baro scale fixed - TDS GTNXi integration added - Updated manual https://krakenfiles.com/view/YKjFnLHppC/file.html |
« Next Oldest | Next Newest »
|
Users browsing this thread: 2 Guest(s)