JustFlight PA-28R Arrow III v0.1.0

[zebulon]

Hi,





http://dl.free.fr/vfsxKpFlz

[zebulon]

Hi,

Just Flight - PA-28R Arrow III v0.2.0
The PA-28R Arrow III for Microsoft Flight Simulator features an impressive sound system, native model and 4096 x 4096 PBR materials for the highest possible texture detail and clarity.
Note
Check Readme
http://dl.free.fr/sf1zhJGjm

[zebulon]

Hi,

v0.3.0
Checklists added (manual and automatic/co-pilot modes supported)
Direction Indicator (DI) bezel now illuminated by panel lighting
Whiskey compass animation fixed
Sun visor animation now visible from exterior
GNS 530 display now remains visible after GPS unit toggle on EFB is used
Landing gear auto-extension logic fixes
Airspeed indicator (ASI) needle accuracy issue fixed
Airspeed indicator (ASI) TAS scale fixed
Yoke timer paused when yoke hidden - fixed
ON/OFF control assignments now supported (e.g. lights, master/alternator)
Autopilot OMNI/VOR hold disengaging after flying overhead VOR - fixed
Autopilot mode engagement logic fixes
HSI no longer drifts
Aircraft type now included in ATC calls
inHG baro scale added to standby altimeter
Yoke visibility, emergency gear lever, co-pilot, chock, tie-down and towbar selections, COM/NAV/ADF frequencies and fuel load are now included in state saving
Chock, tie-down and towbar selections can now be made via LVars for use by cockpit builders, VR users etc
KMA 20 audio selector logic fixes
Paint kit horizontal stabiliser texture fixes
Yoke pitch animations added to exterior model
Further VR compatibility tweaks (including larger clickspots for small controls, fixed EFB power and GPS 100 buttons)
COM/NAV volumes now set to 100% when ending flight in Arrow III to prevent issues with other aircraft
Flap lever vibration when using control axis - fixed
GNS 430/530 not powering up when avionics master control is assigned - fixed

https://anonfiles.com/k5PeN0mau4/FS2020_...V0.3.0_rar

[zebulon]

Hi,,

v0.4.0
https://file.cm/bmm4gsu587sv

[zebulon]

Hi,

V0.5.0
https://file.cm/7v1doo2z179o

[zebulon]

Hi,

v0.5.1
https://file.cm/1pl7t7mbdcvm

[zebulon]

Hi,

v0.5.2

https://file.cm/rxapxcr73jpz

[zebulon]

Hi,

v0.6.0
https://file.cm/tynp22obfjej

[zebulon]

Hi,

v0.7.0
- Improved cockpit lighting*
- EFB brightness controls and battery power logic added
- VR compatibility tweaked for easier use of GTN 750
- Audio ident/selector fixes
- Autopilot altitude hold logic tweaks
- Landing gear drag reduced
- KX170/KX175 COM and NAV frequencies can now be controlled using the 'Increase/Decrease COM/NAV (WHOLE/FRACT)' assignments
- Aileron inputs disabled whilst autopilot is engaged to prevent control issues
- RPM drop with prop lever movement fixed
- Dome light non-illuminated texture fixed, state of knob now saved
- Autopilot Nav*source select can now be assigned to a control
- Fuel state is now saved

https://file.cm/8eee25ph2nb5

[zebulon]

Hi,

v0.7.1
https://file.cm/zgm9uzjkw54y

[zebulon]

Hi,

v0.8.0
- Autopilot logic fixes (including bank hold, altitude hold accuracy)
- Landing gear lights now dim when the panel lighting is switched on
- AP nav 1/2 selector fixed
- Whiskey compass accuracy improved
- External equipment now visible in VR
- Minor sound fixes and EFB sounds added
- KN62 inner knob push/pull for 0.5 KHz selection added
- KMA20 COM 1 receive logic fixed
- Cabin heat now prevents windshield icing
https://file.cm/usceua54qkn3

[zebulon]

Hi,

v0.9.0
- PMS-50 GTN 650 integration
- FDE Tweaks
- Autopilot control assignments fixed
- Landing gear lights dim more with panel lighting switched on
- EFB sounds on/off clickspots added
- Cockpit texture tweaks for improved appearance
- KN62 inner knob animation fixed
- Sim Update V control system compatibility fixes:
* Cabin heating controls
* Parking brake lever
* Window latch
* HSI and DI knobs
* GPS 100 ON/OFF button
https://file.cm/cwdwpe2chcoj

[zebulon]

Hi,

v0.10.1
Note: SEE README.TXT AFTER EXTRACTING! Please follow the activation procedure again even if you used previous version of this aircraft.

Changelog :
v0.10.1:

Elevator trim axis has limited range - fixed
PMS GTN 650/750 not powering up (bundle only) - fixed
COM/NAV radio volume and power logic improvements
Further tweaks to cockpit instrument reflections
Cockpit screen clickspot logic improvements
Landing light effect repositioned for better match with model
Pilot visible when cold & dark - fixed

v0.10.0:

Exterior model parts (e.g. pilot) showing up in cockpit when a flight is ended - fixed
EFB tab black edges - fixed
Version number is now shown on the top bar of the EFB
OAT is now shown on the top bar of the EFB (Fahrenheit or Celsius depending on selected MSFS unit of measure)
Wheel touchdown effects added
Arrow III, Turbo Arrow III and IV variants now have unique rather than shared state saving
The alternate air lever can now be controlled using the SET ANTI ICE and TOGGLE ANTI ICE assignments
Cabin heat control interactions fixed
Beacon light no longer remains off when in cockpit view
PUMP ON and PUMP OFF assignments can now be used to control the fuel pump switch
Elevator trim axis direction reversed to match behaviour of default aircraft
Panel lighting will now be set according to weather conditions as well as time of day as part of the aircraft states
KN62 DME speed/time not shown after flight has been restarted - fixed
Autopilot roll instability - fixed
Autopilot roll knob can now be controlled using the AILERON TRIM LEFT/RIGHT assignment
Radio lights can now be manually adjusted with SET NAV LIGHTS assigned
Elevator trim wheel tooltip and mouse-wheel sensitivity - fixed
Dome light knob tooltip - fixed
Dome light will now fail if the overhead lights CB is pulled
COM/NAV volume now included in state save
Propeller texture/material tweaks
Transponder ident added
Exhaust heat haze direction fixed
Yoke timer usability in VR fixed
Sun visor reflections fixed
GPS 100 headwind/tailwind logic fixed
Exterior lighting effects improved
Instrument reflections reduced
Correct ASI and RPM scales added to HUD
Missing co-pilot fixed
Mixture lever can be moved to idle cut-off with the lock engaged but the engine doesn’t cut - fixed
https://file.cm/j8btv546i6ya

[zebulon]

Hi,

v0.10.2
Note: SEE README.TXT AFTER EXTRACTING! Please follow the activation procedure again even if you used previous version of this aircraft.
- Autopilot roll control logic rewritten for greater reliability and accuracy
- HUD flap scale fixed
- Rudder trim animation improved
- Elevator trim animation improved
- NAV 1 ident not audible - fixed
- DATCON and HOBBs animations fixed
- GPS 100 heading value no longer affected by drift
- Autopilot LOC mode fixed
- Autopilot now supports on/off control assignments
- FDE improvements
- Pilot no longer visible in hanger view
- Minor sound tweaks
- ASI TAS scale position now included in state saving
- TDS GTNXi integration added
- Updated manual
https://krakenfiles.com/view/XaiUSNfdsf/file.html